![j-std-001g spacestatin symbol j-std-001g spacestatin symbol](https://ars.els-cdn.com/content/image/1-s2.0-S0094576519312858-gr5.jpg)
IPC J-STD-001G Soldering Electrical and Electronic Assemblies certification.Miniature/Microminiature (2M) certification in accordance with NAVSEA TE000-AA-MAN-010/2M.Maintain at least ONE of the following certifications:.Completed Navy Electronic Technician (ET) †A†school (Course Identification Number A-100-0149) or similar military or civilian equivalent technical training.Required Education, Skills, Knowledge, and Abilities: Basic Qualifications: * Four (4) years of relevant technical experience. Security Clearance Requirements: * Must possess an active or interim SECRET security clearance, and maintain it for the duration of employment. Install, overhaul, and test equipment in accordance with customer requirements.Utilize government documentation such as engineering drawings, technical manuals, and repair standards to conduct maintenance tasks.Perform repair and maintenance tasks on equipment that is complex, with a variety of complicated components.
![j-std-001g spacestatin symbol j-std-001g spacestatin symbol](https://upload.wikimedia.org/wikipedia/commons/thumb/0/00/Apollo_program.svg/1200px-Apollo_program.svg.png)
#J std 001g spacestatin symbol how to
What do you get upon completion of the IPC J STD Certification or specialist re-certification ?Ī review of your knowledge of looking up anything in the standard as well as how to apply the standard. What’s in the IPC J-STD-001 specialist re-certification class? IPC J-STD-001 specialist re-certification students will discuss applicable changes. When there are revisions and/or amendments to this standard. This IPC Certification class is intended to be at a pace that assumes the students utilize the standard in the workplace. In the IPC J STD-001 CIS recertification class for specialists, students will discuss and review the J-STD-001 standard. This means students must be "check out" in their hand assembly skills to solder components-both throughhole and surface mount as well as wires. In addition, hand skills are confirmed based on the modules that were initially certified to. This re-certification is required every 2 years and includes an accelerated review of the IPC J-STD-001 printed circuit board and wire and terminal assembly standard as well as the testing of the same. The IPC J-STD-001 Re-certification class is one of the methods for re-certifying to the IPC J-STD-001 at the CIS level. IPC J-STD-001 CIS RE-CERTIFICATION COURSE